Events

Abstract – Application of power electronics is widespread in everyday
life. Some applications are considered as “nice to have it;” in other cases,
they are essential. This presentation discusses a wide variety of daily-used
applications around the world. Also covered is an advanced topic, such as SMART
Controller that today’s grid requires for voltage regulation, power factor
regulation, unbalance voltage/current regulation, harmonic elimination and so
on. A SMART Controller that is based on functional requirements and
cost-effective solutions is derived from utilizing the best features of all the
technical concepts that are developed until now. Final year students of
electrical engineering undergraduate curriculum, post graduate students,
researchers, academicians and utility engineers will benefit from attending
this course. The participants will hear from an expert who actually designed
and commissioned a few utility-grade SMART controllers since their inception in
the 1990s.

 

Speaker’s
Bio

Kalyan Sen, a
Fulbright Scholar, is the Chief Technology Officer of Sen Engineering
Solutions, Inc. (www.sentransformer.com) that specializes in
developing SMART power flow controllers—a functional requirements-based and
cost-effective solution. He received
BEE,
MSEE, and PhD degrees, all in Electrical Engineering, from Jadavpur University,
India, Tuskegee University, USA, and Worcester Polytechnic Institute, USA,
respectively. He also received an MBA from Robert Morris University, USA.

 

Dr.
Sen spent more than 30 years in academia and industry and became a Westinghouse
Fellow Engineer. He was a key member of the Flexible Alternating Current
Transmission Systems (FACTS) development team at the Westinghouse Science &
Technology Center in Pittsburgh. He contributed in all aspects (conception,
simulation, design, and commissioning) of FACTS projects at Westinghouse. He
conceived some of the basic concepts in FACTS technology. He has authored or
coauthored more than 25 peer-reviewed publications, 8 issued patents, a book
and 4 book chapters in the areas of FACTS and power electronics. He is the
coauthor of the book titled, Introduction
to FACTS Controllers: Theory, Modeling, and Applications, IEEE Press and
John Wiley & Sons, Inc. 2009, which is also published in Chinese and Indian
paperback editions. He is the co-inventor of Sen Transformer.

Seminar by IEEE Ottawa Section, PELS, SSIT, RS-PEL, PES, Education Activities, Algonquin College IEEE Student Branch, ComSoc, CESoc, and BTS Ottawa Joint Chapter.

The IEEE Ottawa Section is inviting all interested IEEE members and nonmembers to a seminar

Modern Day Applications of Power Electronics – Who Can Benefit?

By 

Kalyan K. Sen

Sen Engineering Solutions, Inc.

DATE:

November 28th 2019

TIME:
Refreshments, Registration and Networking: 18:00;
Seminar: 18:30 – 20:00.

PLACE:
Algonquin College, Room P208, 1385 Woodroffe Ave., Ottawa.

PARKING:

Parking in Lots 8 and 9 after 5 p.m. is $5 flat rate, pay at a
machine and display the ticket on your dashboard.

ADMISSION:

Free. Registration required.

Please register by e-mail contacting: ottawapels@gmail.com

Abstract:

Application of power electronics is widespread in everyday life. Some applications are considered as “nice to have it;” in other cases, they are essential. This presentation discusses a wide variety of daily-used applications around the world. Also covered is an advanced topic, such as SMART Controller that today’s grid requires for voltage regulation, power factor regulation, unbalance voltage/current regulation, harmonic elimination and so on. A SMART Controller that is based on functional requirements and cost-effective solutions is derived from utilizing the best features of all the technical concepts that are developed until now. Final year students of electrical engineering undergraduate curriculum, post graduate students, researchers, academicians and utility engineers will benefit from attending this course. The participantswill hear from an expert who actually designed and commissioned a fewutility-grade SMART controllers since their inception in the 1990s.

A joint event by IEEE YP & WIE Ottawa!

REGISTER NOW: https://forms.gle/ymzcQyp24vNJhx8K8

WHO? Representatives from Professional Engineers Ontario
WHAT? Clarifying the Path to becoming a P.Eng.

If
you are an engineering undergraduate or post-graduate student, or a
recent graduate starting out your engineering career, then this seminar
might be for you. In it you will learn:

• What is PEO?
• What engineering experience is PEO looking for once I graduate?
• I have international engineering education and experience; how is that evaluated by PEO?
• How is my engineering experience evaluated by PEO?
• How do I prepare my Experience Record?
• What is the PPE?
• What is the EIT Program and the Student Membership program?

WHERE?
Carleton University,
Minto Centre (MC) 5050
Paid Parking Available – carleton.ca/parking/parking-map/

WHEN?
Thursday, February 27th, 2020
6:00PM to 7:30PM

Free for all – You MUST pre-register!
REGISTER NOW: https://forms.gle/ymzcQyp24vNJhx8K8

NOTE: This event as been cancelled due to COVID-19 precautions

Seminar presented by the IEEE Ottawa Section, Communications Society, Consumer Electronics Society, and
Broadcast Technology Society Joint Chapter (ComSoc/CESoc/BTS), Instrumentation & Measurement
Society Chapter (IMS), Reliability Society and Power Electronics Society Joint Chapter (RS/PELS), IEEE
Ottawa Educational Activities (EA) and Algonquin College IEEE Student Branch:

IEEE Ottawa Section is inviting all interested IEEE members and nonmembers to a distinguished Lecture:
Drone-assisted Mobile Edge Computing

By

Nirwan Ansari, Distinguished Professor of Electrical and Computer Engineering at

the New Jersey Institute of Technology (NJIT)

 

DATE:

Thursday, March 19, 2020.

 

TIME:

Refreshments, Registration and Networking: 6:00 p.m.; Seminar: 6:30 p.m. – 7:30 p.m.

PLACE:

Ciena Optophotonics Lab, Room T129, T-Building, School of Advanced Technology, Algonquin College,

1385 Woodroffe Ave., Ottawa, ON Canada K2G 1V8.

 

PARKING:

Parking at Lots 8 and 9 after 5 p.m. is $5 flat rate, pay at a machine and display the ticket on your dashboard. Please respect restricted areas.

ADMISSION:

Free. Registration required. To ensure a seat, please register by e-mail contacting: Wahab Almuhtadi.

 

MORE INFO:

Ottawa ComSoc/CESoc/BTS Chapter website.

Abstract:

In mobile access networks, different types of Internet of Things (IoT) devices (e.g., sensor nodes and smartphones) will generate vast traffic demands, thus dramatically increasing the traffic loads of their connected access nodes, especially in the 5G era. Mobile edge computing enables data collected by IoT devices to be stored in and processed by local fog nodes as well as allows IoT users to access IoT applications via these nodes at the same time. In this case, the communications latency critically affects the response time of IoT user requests. Owing to the dynamic distribution of IoT users, drone base station (DBS), which can be flexibly deployed over hotspot areas, can potentially improve the wireless latency of IoT users by mitigating the heavy traffic loads of macro BSs. Drone-based communications poses two major challenges: 1) DBS should be deployed in suitable areas with heavy traffic demands to serve more users; 2) traffic loads in the network should be allocated among macro BSs and DBSs to avoid instigating traffic congestions. Therefore, we propose a TrAffic Load balancing (TALL) scheme in such drone-assisted fog network to minimize the wireless latency of IoT users. In the scheme, we divide the problem into two sub-problems and design two algorithms to optimize the DBS placement and user association, respectively. Extensive simulations have been set up to validate the performance of TALL.

Speaker Bio:

Dr. Nirwan Ansari, Distinguished Professor of Electrical and Computer Engineering at the New Jersey Institute of Technology (NJIT), received his Ph.D. from Purdue University, MSEE from the University of Michigan, and BSEE (summa cum laude with a perfect GPA) from NJIT. He is a Fellow of IEEE and a Fellow of National Academy of Inventors.

He authored Green Mobile Networks: A Networking Perspective (Wiley-IEEE, 2017) with T. Han, and coauthored two other books. He has also (co-)authored more than 600 technical publications. He has guest-edited a number of special issues covering various emerging topics in communications and networking. He has served on the editorial/advisory board of over ten journals including as Associate Editor-in-Chief of IEEE Wireless Communications Magazine. His current research focuses on green communications and networking, cloud computing, droneassisted networking, and various aspects of broadband networks. He was elected to serve in the IEEE Communications Society (ComSoc) Board of Governors as a member-at-large, has chaired some ComSoc technical and steering committees, is current Director of ComSoc Educational Services Board, has been serving in many committees such as the IEEE Fellow Committee, and has been actively organizing numerous IEEE International Conferences/Symposia/Workshops. He is frequently invited to deliver keynote addresses, distinguished lectures, tutorials, and invited talks. Some of his recognitions include several excellence in teaching awards, a few best paper awards, the NCE Excellence in Research Award, several ComSoc TC technical recognition awards, the NJ Inventors Hall of Fame Inventor of the Year Award, the Thomas Alva Edison Patent Award, Purdue University Outstanding Electrical and Computer Engineering Award, the NCE 100 Medal, and designation as a COMSOC Distinguished Lecturer. He has also been granted more than 40 U.S. patents.

Speaker: Suzanne
Grant of Canadian Advanced Technology Alliance

_{Topic: #TechnologyNorth – the gold standard}

Suzanne envisions a world where a Made in Canada #TechnologyNorth seal is the global gold standard of quality, synonymous with leather shoes Made in Italy, grapes harvested in Champagne, and autos designed and manufactured in Germany. Canada’s world class innovators have delivered excellence decade over decade. Without adequate support of the sector through COVID19, this vision may be a non-starter. During economic difficulties Canada has traditionally bailed out traditional auto and airline industries, and innovative technologies like the AVRO Arrow, Nortel, Research In Motion, Cognos and aspiring young companies were orphaned. By failing to protect our  innovators, Canada traded in future traction of Canada’s valuable intellectual property. America, Europe and the Middle East hungry to prosper from our bargain IP and talent came out the winners. Each downturn has taken at least a decade for technology to reinvent itself and rebound.

We have a track record of great beginnings and a more mature Canada can weather the storms and aim for bigger commercial finish lines, where prosperity and job abundance translate to big returns. Before COVID19 struck, we were hitting our stride with record venture investments and sought after talent from leading education institutions. Canada’s Innovation Agenda demonstrated a maturing future view aiming to lead. This is no time to retreat! The government has invested on behalf of Canadians and accountable for a $36B year over year injection into innovation via universities and commercialization. This investment is at risk. Toronto was the fastest growing tech hub in North America with ICT and advanced technologies outpacing job and economic growth rates by almost twice the national average. As we look beyond COVID19, our technology sector, adequately supported through this crisis, can be the catalyst to jump start Canada’s future economy. With a troubled oil and gas sector, Canada will need agile, fast movers doing the heavy lifting to fund our social, health and education programs and rebuild the nation’s balance sheet.

And as we get back to shipping products and services, a more sophisticated approach to sales, branding, advocacy and public relations, layered with Canada’s science, technology, engineering and maths genius can place Canada out in front in multiple lanes. The digitization revolution just got a bump up and opportunities and demand will remain for trillion dollar market frontiers. Data, Internet of things and machine learning are golden.  Demand for artificial intelligence, environmental, medical and space solutions will continue to accelerate. Winning the future will take more collaboration, agility, commercial savvy and embracing diverse talent sets and creativity. We’ve got this Canada!

About The Canadian Advanced Technology Alliance
CATA is a trusted industry alliance with a mandate to help Canadian innovation thrive. They focus on commercial capabilities and market access for Canadian HQ small and medium technology businesses. The alliance brings together industry thought leaders with academe and policy makers to advocate for Canadian competitiveness. CATA amplifies a bold, confident podium culture amongst Canadian innovators. CATA recently proposed $3.6B in COVID emergency relief – the Resilience and Rebound Fund for tech small and medium companies.
CATA is home to the National Innovation Leadership Council, and a joint body with the Canadian Association of Chiefs of Police – the CACP/CATA E-Crimes Cyber Council. CATA is launching a President’s Council this Fall